How can interior doors be installed in just one day?

We use advanced 3D robotic scanners to measure your existing door frames down to 1/1,000th of an inch. Because we cut, paint, and finish the doors off-site in a factory, our installers only need to bring them to your home and hang them. This eliminates all on-site construction delays.

Are these doors painted and finished before arrival?

Yes, every door is painted with multiple coats and cured in a dust-free, climate-controlled factory environment. This process creates a smooth, incredibly durable finish that is far superior to hand-painting. Best of all, there are zero paint fumes or wet paint messes in your home.

How does Tampa's humidity affect the newly installed doors?

Our doors are factory-sealed on all six sides, including the top and bottom edges. This comprehensive seal prevents moisture from Florida's humid air from penetrating the wood core. As a result, your doors will not warp, swell, or stick like traditionally painted doors often do.

Do I need to clean up messy sawdust after the installation?

No, there is no messy cleanup required. Because all trimming, cutting, and prep work are handled at our off-site manufacturing facility, we do not generate sawdust in your home. Our installation crew vacuums the work areas and leaves your home spotless before they leave.

Door Replacement Installation Process in Tampa

Replacing an exterior door involves more than swapping one panel for another. For a Tampa home, the installer should assess the opening, select a suitable assembly and plan how to protect the threshold and surrounding wall from weather. The exact steps depend on the door and the condition of the existing frame.

Assessment and product selection

A consultation starts with measurements, swing direction, frame and sill condition, hardware needs and finish preferences. Ask for the manufacturer and model of the proposed door and frame. If impact protection is required, review the applicable Florida Product Approval or Miami-Dade Notice of Acceptance for the complete configuration. A claim of rapid installation does not replace this preparation.

Removal and installation

The crew should remove the existing unit, inspect the opening and discuss any damaged material found. The new frame must be installed and fastened according to its requirements, then sealed and adjusted for operation. Confirm who handles trim, locks, cleanup, permits and inspections in the written proposal. Ask how any change to the scope will be approved before work continues.

Final checks and support

Before completion, test the door's swing, latch, lock and weatherstripping. Keep the product documents, approvals and separate workmanship warranty. STH Windows & Doors can discuss the steps for your specific entry-door replacement and prepare a proposal without promising a one-day process that may not fit every home. Contact STH Windows & Doors to plan your project.